If you have a document open, go into the ‘ Tools’ tab, but this time select ‘ Attach’.This will connect your computer to the machine using the protocol you have just selected. If there is not a document open, from the ‘ Tools’ tab, select ‘ Connect’. Finally, you need now just to connect to the machine.From the list, select ‘ Faro Devices’, and then ‘ OK’.The parameters button, as suggested, allows you to change some of the parameters associated with the device i.e.: scan density etc.The following configuration box will open, and you will need to select the correct protocol. To do this, navigate to the ‘ Tools’ tab and select ‘ Configure’. First you will need to select the protocol to use.Insert the FaroArm’s USB cable into the USB port o f your computer.Make sure the FaroArm is plugged in and switched on.On selecting the link for download, a new tab will open up where you can download your driver. D ownload and install th e FaroArm USB driver from the Faro website here (download instructions also included):.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |